Mount Balusters Without Drilling Into Wood Floors

Be careful not to over tighten your connector.

Mount balusters without drilling into wood floors.

Slide the baluster into the top handrail first and then drop it down into the hole in the floor tread. Remember to begin drilling vertically into the railing but once the screw connects with the wood adjust your drill to finish at the correct angle. If the bottom portion of the wood baluster does not want to come up try rotating it counter. The following visual guide showcases 6 different methods of installing square balusters with and without shoes.

Basically you want the size of the hole to allow the iron baluster to fit into it snugly. Measure and cut your balusters 3 4 longer than the distance from the bottom of the handrail to the top of the base tread floor. If you are installing the metal balusters in the same location as the old wood balusters you need to check the size and depth of the existing holes. Make sure everything lines up and the pattern is correct before adding glue.

This makes iron baluster installation clean easy and most importantly secure. Use your best judgement as you should know the material you are installing into step 5 cutting iron balusters to size. Hi so we did have to drill into the drywall. Not so tight that it has to be beaten down on top of it but not loose either.

First slide your baluster shoe onto the baluster. Typically if your baluster extends into the upper hole 1 and the lower hole the depth of the upper hole is 1 2 deep. Square baluster installation tips. So drill a test hole and check the size.

Metal balusters that are 1 2 inch square will require that you drill at least a 3 4 hole in the floor and handrail surface. Round hole with base shoe by far the fastest and easiest method. Insert the included installation screw into the connector and using a drill attach the connector centered on the marked locations. Some balusters are simply toe nailed into place.

This kit works great for banisters but as far as i know there is nothing that will allow you to avoid drilling into a wall other than attaching a piece of wood to it but then you would have to drill the wood somehow or using a pressure mount gate. Step 7 epoxy base shoes. Drill 1 4 inch to 1 2 inch into the tread floor. Others are installed into a hole in the handrail and may have a wood dowel in the base which goes into the tread or floor.

The end of the baluster is rounded into a dowel. This requires drilling a round hole and using a shoe to hide the left over gaps.