You can then create a woodgrain finish with your brush using a strié technique.
Minwax gel stain steel door.
Use the angled brush to get into any nooks crannies or edges.
Make the grain color with a darker paint and clear glaze.
Stir minwax gel stain until creamy before use and occasionally during use.
Remove door hardware and apply painter s tape where needed optional.
When you are finished allow the stain to set for around 30 minutes.
How to gel stain over a painted exterior door.
Bruce recommends starting on a flat surface towards the outside of the door.
Gel stain can be applied with either a natural bristle brush or a lint free cloth.
Then apply a base coat of the lightest wood shade.
With a damp rag clean front doors and allow to dry.
Using a high quality natural bristle brush spread a thin even coat over the entire surface starting with the raised panel sections.
Most gel stains begin to set in a matter of one to two minutes.
There must not be any extra stain parts on your door as this will make your work look uneven.
Using a high quality natural bristle brush spread a thin even coat over the entire surface starting with the raised panel sections.
Paint a layer of stain onto the steel door with the roller.
Work in the direction of the steel s grain.
Are you against using minwa gel stain.
Allow 24 to 48 hours for the stain to dry completely.
Allow three minutes for the wood to absorb the stain and then wipe off any excess stain with a rag.
Prime the steel door with a rust proof primer.
As much as possible try to imitate the natural texture and grain direction of real wood.
Stir minwax gel stain until creamy before use and occasionally during use.
Dip the rag in gel coat and apply the gel coat onto your metal door.
Make sure the door surface is free of all dirt and foreign matter.
I can certainly go darker with one of colors general finishes carry but besides colors do you think general finishes gel stain is far superior than other brands.
Minwax gel stain is a non drip stain that adds natural colors and accentuates the beauty of a wide range of wood and non wood surfaces including wood plywood veneer fiberglass metal and molded fiberboard.
Make sure the door surface is free of all dirt and foreign matter.
Make sure that you smooth out the gel coat evenly on the metal door making sure that it is spread out.
Don t brush over set stain or it will lift from the steel and fail to penetrate.